Hoses & connectors: $100–$200
The brittle old flexible behind the cooktop: tiny part, outsized share of the leaks we find.
Licensed Gasfitters
Gas Work Done
Properly Across
Baulkham Hills
Gas does not grade on a curve. A connection is either tested and certified or it is a liability with a warranty problem, so every gas job we do across Baulkham Hills, from a cooktop swap to a full outdoor kitchen line, ends the same way: needle steady on the manometer, appliances burning blue, paperwork done.
- Licence 368473C, fully insured
- Every job pressure-tested to AS/NZS 5601
- Smell gas now? Leave & call 131 909 first
Why The Law Keeps Gas Licensed In Baulkham Hills
NSW reserves every gas task, down to connecting an oven, for licensed gasfitters, and the logic is unsentimental: plumbing mistakes stain ceilings, gas mistakes burn houses and poison air. The leaks we attend have a recurring origin story, and it is rarely the pipework’s idea, it is a confident DIY connection or a handyman’s thread tape, discovered later by someone’s nose.
What the licence actually buys is the ending: the whole installation held against a manometer until the needle refuses to move, every appliance checked for a clean blue burn and honest ventilation, and the work done to AS/NZS 5601, the clause your insurer reaches for when something ever goes wrong. Across Baulkham Hills and the Hills District, no gas job of ours skips that ending.
If you smell gas in a block
The procedure does not change because you have neighbours, but the urgency does, a leak in a shared building affects everyone on that riser.
Every job finishes on a pressure test with a certificate. Gas has no visible half-finished state: an installation either holds and is certified, or it is not complete.
Leave, take others with you, and call 131 909 from outside. Then notify the building manager. Do not attempt to isolate anything in a common meter room yourself; the network operator attends around the clock and that is what they are for.
Gas in an apartment: what is yours
In a block, the supply to the building and the risers are common property; the pipework and appliances inside your lot are generally yours. Individual meters may sit in a common meter room, which frequently confuses the question of access.
Establish it before arranging work. Anything on common property needs the owners corporation to authorise it, and a plumber cannot simply proceed because a resident asked.
Adding or moving gas in a strata property
Putting a gas cooktop where there was not one, or moving an appliance during a renovation, is rarely just plumbing in a block. It usually requires an owners corporation approval, sometimes a by-law, and always correct ventilation and flueing for the space.
We will tell you what the work needs before you go to the committee, so the application you submit is the one that gets approved rather than the one that comes back with questions.
What gas work costs in Sydney in 2026
Indicatively: a pressure test and leak location generally $220-$450; a new bayonet or appliance point $350-$800 depending on the run; an appliance service $180-$320; a cooktop changeover $250-$500 where the point already exists.
Those are market figures rather than our quote. Your number is agreed before work starts, and every job includes the compliance certificate rather than adding it.
Renting, and gas
A gas leak is an urgent repair under NSW residential tenancy law, and landlords are obliged to arrange it promptly. If you smell gas, ring 131 909 first and the agent second, the network operator does not wait for anyone's authorisation.
Landlords are also responsible for ensuring appliances are safe. If a heater in a rental has never been serviced and burns yellow, that is a request worth putting in writing rather than living with.
What it costs in Baulkham Hills
Joints & fittings, $200–$600
Thread and valve leaks sealed properly and proven again on the gauge.
Pipe runs, $400–$1,500
Corroded or damaged sections replaced; concealed lines with access work run $800–$2,500.
Appliance connections, from ~$200
Connected, tested, certified. New line or bayonet to reach it quoted fixed on top.
The market rate, $120–$220/hr
Sydney's 2026 licensed-gasfitter range; attendance typically $80–$150. Certification is included, because without it there is no job.
No gas job of ours ends without holding pressure on a gauge, that is the receipt that matters. Figures here are indicative of the 2026 Sydney market rather than a quote from us, you get your own number as a fixed price before any work starts.
Anatomy Of A Gas Job
Step 01
Step 01
Supply Off, Air Moving
Suspected leaks start with isolation at the meter and ventilation. Diagnosing a system still feeding its own leak is how amateurs get hurt.
Step 02
The Gauge Does The Accusing
A manometer proves whether the installation loses pressure; detection fluid and instruments then walk it back to the guilty joint or run.
Step 03
Compliant Replacement Only
The failed piece is replaced with compliant material to AS/NZS 5601, one connector or a full rerun, never sealant and optimism.
Step 04
Hold, Relight, Certify
The whole installation holds on the gauge, appliances relight to clean blue flames, ventilation checks out, and the compliance record is yours.
That Cooktop Won’t Connect Itself
Nor should it, legally. One visit: connected, tested, certified, warranty intact. The proper way is also the cheap way, counted honestly.
No. Gasfitting is licensed work in NSW with no handyman tier, and that is not bureaucratic caution, unburnt gas and incorrectly burnt gas are both lethal, and the second is odourless. Unlicensed gas work also voids home insurance, invalidates appliance warranties, and surfaces during a sale.
Blue and steady. Yellow, lazy or lifting flames mean the air-to-gas ratio is wrong, a blocked jet, a starved supply, insufficient ventilation, or an appliance set up for the wrong gas type. It is the one diagnostic anyone can do without equipment, and it is worth a look at every appliance once a year.
Leave the building and take everyone with you. No light switches, no appliances, no phone calls made inside: a switch operating is an ignition source. From outside, ring 131 909, the gas network's emergency line, staffed around the clock. They attend and make the supply safe at no cost to you.
The supply to the building and the risers are common property; pipework and appliances inside your lot are generally yours. Individual meters may sit in a common meter room, which frequently confuses access. Establish it before arranging work, common property needs the owners corporation to authorise it.
Often, but it is rarely just plumbing. It usually needs owners corporation approval, sometimes a by-law, and always correct ventilation and flueing for the space. We will tell you what the work requires before you go to the committee, so the application you submit is the one that gets approved.
Same procedure, more urgency: a leak on a shared riser affects everyone on it. Leave, take others with you, ring 131 909 from outside, then notify the building manager. Do not attempt to isolate anything in a common meter room yourself.
Get The Gas Done Properly In Baulkham Hills
Licensed hands, a passing pressure test, and the certificate to prove it. Smelling gas this minute? 131 909 from outside comes before this form.
